PCFS file preparation

This assumes the experiment is called t09345. Change as appropriate.

  1. *scp the .skd files to oper@hobart:/usr2/sched and oper@ceduna:/usr2/sched
  • On hobart, log in as oper, then:
cd /usr2/sched
drudg
> t09345.skd
> Ho
? 11
7 1 1 1
> 3
> 12
> 0
Now set up the procedure files:
mv t09345ho.prc /usr2/proc
cd /usr2/proc
emacs t09345ho.prc

Add these at the end:

define  unloader      00000000000x            
enddef
define  loader        00000000000x            
enddef
define  systemp       08252022938x
xdisp=on
"tsys1 are sefd (i.e. in jy) for recorded channels 1
xdisp=off
data_valid=off
sy=/usr2/st/bin/tsys -f 203,213 -s -i 0 -n 2
data_valid=on
enddef
define  sefd     000000000000
systemp
enddef
define  midob         08252023503x
sy=run setcl adapt &
enddef
define  preob         08252023450x
systemp
enddef
define  postob        08252024000x
"
enddef

The SEFDs are nominal values and should be checked and changed if there's time

  • Repeat on ceduna (except "Cd" instead of "Ho"). The end of the procedure file for Ceduna should look like this:
define  unloader      00000000000x            
enddef
define  loader        00000000000x            
enddef
define  systemp       08252015950x
data_valid=off
sy=/usr2/st/bin/tsys -f 30,41 -s -n 2 -i 2 rakbus
data_valid=on
enddef
define  preob         08252015950
systemp
enddef
define  midob         08252020004
clkoff
wth
enddef
define  postob        08252022315
onsource
enddef
define  ready         00000000000x
enddef

The SEFDs are nominal values and should be checked and changed if there's time